The 588GW is roughly trimmed and finely trimmed first, and then tracked at the same time.

The 588GW is roughly trimmed and finely trimmed first, and then tracked at the same time.

1.  EXCITECH EF588GW edge banding is closely followed by pressing, sometimes the glue has not solidified, and the edge banding will be torn off by the edge banding. Head and tail should be aligned after the glue is fully solidified, so as to reduce the probability of separating the edge banding from the board.
2. EXCITECH EF588GW edge banding finishing and edge scraping sometimes have knife jumping or knife vibration at the feed, especially at high speed.EXCITECH EF588GW edge banding Repair the edge before it is flush, and the extra edge banding will eliminate some initial vibration or jump of edge trimming.
3. EXCITECH EF588GW edge banding edge-scraping wire formed by edge-scraping is arranged at the back end, and the edge-scraping wire will be separated from the wooden board after being aligned with the head and tail, thus eliminating the influence of the edge-scraping wire on the subsequent work station, preventing the wire from winding during polishing, and greatly reducing the damage probability of the polishing motor.
4. EXCITECH EF588GW edge banding tracking is placed behind the trimming, which can correct some slight trimming or missing corners.
5. EXCITECH EF588GW edge banding no additional wire breaking mechanism is needed.

• * CAPTCHA: Please select the Car