4. When the edge of the plate is sealed, it always bumps the plate, and sometimes scratches the surface of the plate, which is very expensive. How to solve it?Answer: The reason for knocking the board may be that there is burr on the contact surface of the leveling ruler, which needs sandpaper polishing. Or the guide wheel is damaged and needs to be replaced. The machine can be debugged. You can choose Xinghui full-automatic flexible edge banding machine for high-speed servo horizontal trimming, servo feeding fast sol, and heavy-duty pressure beam lifting structure to make the equipment work more stably.
5. How to solve the time-consuming and labor-consuming problem that the wired glue on the edge of furniture plate is not cleaned cleanly or workers need to clean it again in the later stage?Answer: 0-line adhesive edge banding machine can be used, mainly because of the progress of edge banding technology. Xinghui edge sealing machine adopts hot air edge sealing technology. Seamless edge sealing can solve the problem of thread glue, with short heating time and firmer bonding.
6. Sometimes in the order, there is a small area of plate that needs to be punched. It's very troublesome to place the plate manually and punch it twice. Can you punch it once? What is the minimum plate size?Answer: In general, in order to improve efficiency, double drilling bags are used to drill holes at the same time to improve efficiency. Therefore, if the plate is small and the drill spacing cannot be reduced, it can only be played twice manually. In order to solve this problem, we optimized the structure of drilling package, and the fear of ≥64mm supported double drilling packages to punch holes at the same time, which improved the utilization rate of drilling package.
7. The price of the purchased machine is at a high price in the market, but there are always minor problems in the use process, such as manual debugging after the cutting props run for a period of time, otherwise it will cause the deviation of the cutting of the back plate. Sometimes the cable will break down.Answer: When buying a machine, you must upgrade the configuration. It is better to save money and worry than to repair it many times. The cost of repairing parts is high, so we should avoid these invisible consumption. Time-consuming and labor-intensive will also affect production. Tool magazine can be equipped with servo-driven tool adjustment, which can accurately adjust and reduce standby time and improve productivity. Cable can be selected from German cable, which can prolong service life and reduce damage. There are more high quality accessories to choose from.
Send your message to us:
Post time: Mar-29-2023
