1. Whether there is any foreign matter in each guide rail, rack and pinion and starting point travel switch; obstruction of obstacles will cause gears and coupling parts to wear out too quickly, resulting in a decrease in machine accuracy.
2. Whether the gear and rack occlusion state is normal; the main thing is to check whether the motor is loose, the cutting will collapse and wave patterns, which will cause the machine to "lost steps".
3. What is the condition of the gantry forward and backward gear rack and whether it is normal.
4. Whether the dust of the main electrical box and the fan used for internal cooling is cleaned; the reason is very simple, it is similar to the reason for cleaning the computer, why is your computer cleaned, and the machine is cleaned. (They love clean ones) Always keep small brushes at home.
5. Whether the dust in the dust hood under the main shaft is cleaned; this is very similar to cleaning the beard after shaving.
6. Whether the oil in the gas source triplet (oil-water separator) oil cup is sufficient and whether the guide rail to be lubricated is lack of oil; the main function of the oil-water separator is to remove the water and impurities in the oil, so as to reduce the failure of the injector, thereby extending The service life of the engine. When adding lubricating oil to small parts such as the track, you can choose a needle tube or a small oil sprayer.
7. Whether each emergency stop switch is normal; when the machine is abnormal, it can be forced to stop to prevent secondary damage.
8. Check whether there is dust and foreign matter in the heat sink of each motor;
9. Check whether the pressure of each air pressure gauge is normal. According to the different values of the pressure gauge, the existing failure of the machine can be judged or the failure can be prevented.
The above is the focus of daily maintenance and maintenance of panel furniture cutting machine equipment. In daily use, customers should pay attention to reasonable maintenance according to the specific conditions to avoid failures and extend the processing life of the equipment.
Send your message to us:
Post time: Sep-02-2020
