- Redi se axis ad originale punctum, ut a tergum de moderatoris software, et posuit in compressa sarcina in USB mico coegi vel computer.
- Clean up the dust and impurities on the machine table, table top, drag chain, lead screw, rack and guide rail with gas, then brush the rack and guide rail with lubricating oil (machine tool guide rail oil ISO VG-32~68 is used, and butter is prohibited) to ensure that there is oil on the guide rail and rack of each shaft, and drain the water in the oil-water separator in the bed.
- Mundare impudicitiis super superficiem exercituum rig cum Gas. Et calces arca Dei numeralis control eft Rig necessitates ad repleti Lubricating oleum de filler: 5cc Krupp L32N lubricating uncto.
- Cut off potestas copiam distribution arca, et mundare usque in pulveris in distribution buxum in vacuoing (Nota: Non ictu directe cum Gas, elevatio pulvis et ducunt ad pauperem contactus electronic components). Post Purgato, posuit desiccant in arca.
- Mundare et ponere peripheriam fusum et instrumentum tractare Gas; Mundare superficies tapumed foraminis ad iuncturam cum mollis et munda pannus. Diligenter mundum et tenere a taper superficies ad instrumentum tractare cum degreasing agente, et applicare Lubricant post Purgato.
- Vacuum sentinam vacuum sentinam removere filter elementum, flante mundus. Reprehendo altitudo graphite sheet semel. Vtlf250,360 non minus quam 41mm et vtlf500 non minus quam 60mm. Imple Krupp Amblygon ta-XV / II Lubricating uncto cum 10cc.
- Postquam totum apparatus purgatur et servetur apparatu proprie involvit Smock ne cadens cinis.
Mitte ad nos:
Post tempus: Jan-26-2024
